Print start

Discussions about ideaMaker and other printing software.
Posts: 1
Joined: Sun Aug 07, 2022 8:22 pm

Print start

Postby Matterforce3d » Sun Aug 07, 2022 8:33 pm

Hello. This is my first community joining in my life. I hope I'm right here. I've recently had a problem with my pro2. When starting to print, the printer does not start printing in the middle. the x-axis is 12.5mm and the y-axis is 16mm away from the center of the print bed. you would be very grateful for advice.

User avatar
Posts: 604
Joined: Thu Oct 28, 2021 10:43 pm

Re: Print start

Postby Ryan@Raise3D » Sat Aug 13, 2022 12:23 am

For the pro2 and the Pro3 the print area shown in the ideamaker software is the actual print area the printer can print in, but on the printer itself this is a bit shifted left and towards the front as there is a bit of space near the back and the right side of the printer that the print head cannot reach. This is normal for the machine and this does not affect the advertised print volume.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests