PVA+ printing problem with the E2

Discussions about ideaMaker and other printing software.
Posts: 12
Joined: Sun Apr 25, 2021 4:09 pm

PVA+ printing problem with the E2

Postby Eddi » Sun Jul 31, 2022 12:05 pm

When I print PLA with PVA+, the right extruder clogs after 4-5 layers. I use the Raise PVA+ template.
Extruder temperature on the right is set to 220°C. The extruder pause temperature is set to 180°C . Is the pause temperature too high or too low?

User avatar
Posts: 604
Joined: Thu Oct 28, 2021 10:43 pm

Re: PVA+ printing problem with the E2

Postby Ryan@Raise3D » Sat Aug 13, 2022 1:13 am

The pause temperature of the PVA template is correct at 180 as we need to bring it as low as possible to reduce ooze. Regarding the jamming, can you confirm if the PVA was dried before use as moisture in the filament can start causing jamming.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests