Printing Same Gcode through RaiseCloud Slower?

Posts: 3
Joined: Sat Mar 06, 2021 3:38 am

Printing Same Gcode through RaiseCloud Slower?

Postby Trenth » Mon Mar 15, 2021 7:13 am


I've created some gcode in IdeaMaker and uploaded them to RaiseCloud, but the print speed is significantly slower than the direct file. It's almost as if the entire print is in slow-mo. If I had to guess, the speeds are perhaps 40-50% slower.

IdeaMaker says a print should take 18 minutes, but the Cloud file takes 39 for it. Another one said 2 hours in the slicer and it took 2 hours and 40 minutes through RaiseCloud. Normally, the IdeaMaker estimated times are pretty close, but I don't understand why it's so far off.

Is there some setting in RaiseCloud that changes the units/speed/extrusion?
Screen Shot 2021-03-15 at 12.13.19 AM.png

User avatar
Posts: 7908
Joined: Fri Mar 25, 2016 3:54 am

Re: Printing Same Gcode through RaiseCloud Slower?

Postby Vicky@Raise3D » Tue Mar 16, 2021 8:16 pm

The estimate print time for 3rd party printers are all calcualted according to OCTOPrint's source program, so time is just an estimate.

Return to “RaiseCloud”

Who is online

Users browsing this forum: No registered users and 1 guest