Ideamaker profile for Predator - bug?

Discussions about ideaMaker and other printing software.
Posts: 2
Joined: Mon Jan 11, 2021 9:54 am

Ideamaker profile for Predator - bug?

Postby Vizeroy » Mon Jan 11, 2021 11:18 am


I'm just starting off with Ideamaker and tried 2 different profiles for the predator.
1) a community profile from
2) a basic profile, made with the support site profile creator.

Neither worked for me.
The community made had wrong dimension settings and the nozzle was way too high above the build plate - which I couldn't adjust enough in marlin tuning menu.

The one created on the site raised the x-axis colums on every movement so that even on the first layer, the nozzle built kind of a filament tower / staircase, while still working on the skirt.

When I abort the print then, just the X-axis gets lifted until it jams...
I'm really bad at Gcode. Doesn anyone have a hint on what might be going on?

The affected gcode and data files are attached. (based on the profile, created by the support section)
(3.64 MiB) Downloaded 24 times
(122.23 KiB) Downloaded 25 times

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests