Vase mode issue

Discussions about ideaMaker and other printing software.
the dragonlord
Posts: 22
Joined: Tue Nov 17, 2020 7:52 am

Vase mode issue

Postby the dragonlord » Sat Nov 28, 2020 1:18 pm

Good morning, I can't make vase mode work...with everu model I import if I choose vase mode I optain this horrible artifacts

The problem occors regardless I set or not the thin wall check in the modal dialog wich appears when I start the slicing...

What am I doing wrong?

Senza titolo-1.jpg

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests