Mesh Bed Leveling

Discussions about ideaMaker and other printing software.
s4eric
Posts: 4
Joined: Wed Jul 29, 2020 5:45 pm

Mesh Bed Leveling

Postby s4eric » Wed Jul 29, 2020 6:02 pm

Is there anyway to confirm the mesh bed leveling is working? It appears as though the offsets are not being applied, most noticeably on the first layer. The print will be squished too much on portions of the bed that are higher and not adhere as well on the lower portions. The flatness is within tolerance ~.2 and notice no difference between the simple and full bed leveling.

Auto-leveling is turned on, and I'm using the latest version of IdeaMaker. I have enabled the raft, even for small prints for the time being.

User avatar
Vicky@Raise3D
Posts: 6953
Joined: Fri Mar 25, 2016 3:54 am

Re: Mesh Bed Leveling

Postby Vicky@Raise3D » Thu Jul 30, 2020 12:16 am

Which mode you are printing with?
Mesh bed leveling will be disabled for duplication and mirror mode printing options.

s4eric
Posts: 4
Joined: Wed Jul 29, 2020 5:45 pm

Re: Mesh Bed Leveling

Postby s4eric » Thu Jul 30, 2020 4:48 pm

Duplication mode...I was not aware of that, thanks for the info.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest