Resume after power loss results in large Z gap

detroitus
Posts: 113
Joined: Fri Mar 02, 2018 5:40 pm

Resume after power loss results in large Z gap

Postby detroitus » Fri Jul 10, 2020 3:12 pm

An issue I have been having with my N2 has been that any time there is a failed print due to power loss and I try to RESUME the print, the print bed will immediately drop approximately 10mm before the extruder homes in x-y and purges filament. It will then resume the print job, but now it will be air printing due to the 10mm gap it introduced prior to homing. I cannot figure out why it does this nor how to make it stop, but the behavior is consistent every single time I try to use the RESUME function.

User avatar
Vicky@Raise3D
Posts: 6973
Joined: Fri Mar 25, 2016 3:54 am

Re: Resume after power loss results in large Z gap

Postby Vicky@Raise3D » Sat Jul 11, 2020 1:49 am

Would you like to advise the version of firmwar eyou are using.


Return to “N Series”

Who is online

Users browsing this forum: No registered users and 1 guest