profiles

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Sagie
Posts: 2
Joined: Thu Jun 18, 2020 4:00 pm

profiles

Postby Sagie » Fri Jun 26, 2020 5:52 pm

Hi

Is a profile for N series good also for the pro2 series?
For example, on the approved filaments list there's a profile for eSUN pla+ only for N series - can I use it also for the pro2?

Also, looks like Polymaker are going to discontinue the PolyLite PLA and stay only with PolyMax PLA - is the PolyMax OK too? because there's no profile for it and I prefer to print only with approved filaments that have profiles for pro2.

Thanks

User avatar
Vicky@Raise3D
Posts: 6737
Joined: Fri Mar 25, 2016 3:54 am

Re: profiles

Postby Vicky@Raise3D » Sat Jun 27, 2020 1:10 am

The templates between the N-series and Pro series are similar but not the same. Depending on the material you may need to make small adjustments to the profile to achive the desired result. However, you can use the settings as a good starting point to tune for that particular filament.

Sagie
Posts: 2
Joined: Thu Jun 18, 2020 4:00 pm

Re: profiles

Postby Sagie » Sat Jun 27, 2020 5:07 am

Vicky@Raise3D wrote:The templates between the N-series and Pro series are similar but not the same. Depending on the material you may need to make small adjustments to the profile to achive the desired result. However, you can use the settings as a good starting point to tune for that particular filament.



Thank you.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest