Car issue

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Topsykretts
Posts: 1
Joined: Mon Jun 22, 2020 6:25 am

Car issue

Postby Topsykretts » Mon Jun 22, 2020 10:33 am

Hello everyone :)

Im a new with all 3d printing stuffs.
Im trying to print my car model but i it looks terrible.
The point is, that ugly steps are showing up on easy slope areas (hood for example)
Im using standard Raise3D PLA settings.

Is there posibillity to increase that easy slope destiny to make it more gentle?

Thank you!
Attachments
car screentshot.jpg
Marked areas

User avatar
Vicky@Raise3D
Posts: 6696
Joined: Fri Mar 25, 2016 3:54 am

Re: Car issue

Postby Vicky@Raise3D » Tue Jun 23, 2020 12:35 am

Decreasing the layer height will help make the steps a little less noticeable. But not get rid of it totally. Because slicing software will slice the model by layer, so if the model have slope areas or curve surfaces, it will always have similar result.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest