Mintemp triggering at END of print.

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
IODarren
Posts: 3
Joined: Sun May 17, 2020 10:52 pm

Mintemp triggering at END of print.

Postby IODarren » Sun May 17, 2020 11:07 pm

For the last several prints, I am getting the infamous

"Board Error: Error:00: Extruder switched off. MINT" error popping up. But it is happening at the end of the print, when the print is done and the extruder is homing. The print is completing perfectly, and everything is fine, it's like that error is popping up instead of "your print is done".

any ideas?

User avatar
Vicky@Raise3D
Posts: 6464
Joined: Fri Mar 25, 2016 3:54 am

Re: Mintemp triggering at END of print.

Postby Vicky@Raise3D » Mon May 18, 2020 11:48 pm

Has the using envrionment of where this printer been changed so far?
Would you like to export serial log from this printer and share with us?

IODarren
Posts: 3
Joined: Sun May 17, 2020 10:52 pm

Re: Mintemp triggering at END of print.

Postby IODarren » Tue May 19, 2020 2:16 am

Vicky@Raise3D wrote:Has the using envrionment of where this printer been changed so far?
Would you like to export serial log from this printer and share with us?



The environment has not changed at all.


That said......we have a new development. Now the machine is throwing me the code on boot up, and is forcing me into safe mode.

I just extracted the log from the most recent boot up, and here it is.
Attachments
all-raisetouch-788-20200519021044.tar.gz
(29.72 KiB) Not downloaded yet

IODarren
Posts: 3
Joined: Sun May 17, 2020 10:52 pm

Re: Mintemp triggering at END of print.

Postby IODarren » Tue May 19, 2020 2:25 am

Here are some screenshots of what I'm seeing.
2020-05-18 18.59.19.jpg

2020-05-18 18.07.04.jpg
2020-05-18 18.08.01.jpg
2020-05-18 18.06.50.jpg
2020-05-18 18.06.42.jpg

User avatar
Vicky@Raise3D
Posts: 6464
Joined: Fri Mar 25, 2016 3:54 am

Re: Mintemp triggering at END of print.

Postby Vicky@Raise3D » Wed May 20, 2020 2:54 am

Would you like to share some pictures around your print head to show us the wirings?


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest