Please post your suggestions for hardware features
5 posts • Page 1 of 1
So instead of bed leveling where it level by 10min or the more simple one it only did a measurment around and in the middle of where the print is placed on the bed. So if I have a small part on the middle then it only make a leveling just around and one in the middle of the part printed.
Vicky@Raise3D wrote:If you enable the setting the automatic bed leveling, it will only probe where the part will be printed.
I have bed leveling, but it takes 10min. Could set a faster more simple bedlevelig (from the panel on the machine)
So should I choose the other leveling?
Who is online
Users browsing this forum: No registered users and 1 guest