possible z wobble ?

Steadipanda
Posts: 18
Joined: Fri May 10, 2019 11:41 pm

possible z wobble ?

Postby Steadipanda » Thu Mar 26, 2020 6:21 pm

whats the cause of this ?

im able to reproduce this matter again and gain and it always happen at the same place.

no matter what kind of model it is.

z screws are loose and all X/Y rods are straight (i've disassembled the whole top including belts & couplers and redid everything. and relubricated everything)

it seems only affecting top few layers and bottom few.

im on newest raisetouch 1.2.2 and ideamaker 3.5.2
Attachments
IMG_20200326_132018.jpg
IMG_20200326_131844.jpg

Steadipanda
Posts: 18
Joined: Fri May 10, 2019 11:41 pm

Re: possible z wobble ?

Postby Steadipanda » Fri Mar 27, 2020 2:12 am

i was able to get rid of it in S3D. or in ideamaker with layer start point changed to FIXED, as well as seam hiding to None.

so what happens is everytime when layer changes start point, it squishes the new layer, meaning the whole layer is larger than before. but if it resumes to the previous layer start point then its all good again.

so if i change the layer start point to NEAREST, every other layer will get squished.

i have to say placing the layer start point at that corner makes it super weak. CF nylon is fine. but PLA or abs will snap in half with 2 fingers.
Attachments
91152020_670464276829024_8464034940047065088_n.jpg


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest