Everyone agrees, that a good calibration is the most important thing to start printing.
but noone has knowledge or time to do this. so i demand an auto calibration tool.
we need 2 sensors near the nozzles, who detect the distance etc.
it should guide you through the calibration process, so you just need to change some screws.
nozzle calibration should be also much easier, and should be done from front.
if not, there should be an option to take out the whole nozzle tower easily without tools.
at least x axis could be done by a sensor. this sensor must detect the nozzle to bed distance and check the whole bed at mid and all edges, etc.
this isnt cheap, but hey, 100-300 euro would it be worth as addon!
i hate timewasting stuff.. and pro2 isnt that cheap, so 100 euros wont count...
Please post your suggestions for hardware features
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests