i have got a Raise 3D N2 Plus, and i have been using it for 2 years -during this time i had no serious problems with the machine-.
Last night i put on a 0.6 nozzle for a project, I could only watch first few layers and everything seemed fine. However, this morning (there is a7-8 hours gap) I saw the failed print, probably because I forgot to put clips for the glass on the heatbed. As a result, hotend, heater wires and the fan seriously damaged. i am going to attach some pics to this email, in these pictures you will see the type of error machine is giving.
Until today I have only used left side hotend, I have the right hotend and right heater/wires as spares parts with me. All the damaged parts of the left side have been changed, i have connected right side's spare parts to the left hotend connector. However, as you will see in the pictures the error I am seeing have not changed. I have got a very important project and my time is very limited, so i would like you to help me as soon as possible.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests