hey guys so im using the dual extruder setup with a cyclopse(2 in 1 out) hotend.
so my 1st issue is with printing petg filament and sometimes with pla. doesnt matter how much i set the retraction amount for switch, it tends to jam up, like the one extruder didnt retract enough.
2nd. i noticed when switching from extuder 1 to number two that nr 1 will retract, then nr 2 will also retract x amount then nr 2 will feed x amount, why does it also retract when it is supposed to feed, that causes the extruder not to print the 1st quarter of the priming tower layer
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest