Bad prints / heavy issues

Posts: 1
Joined: Mon Jul 01, 2019 10:31 am

Bad prints / heavy issues

Postby raisen3d » Mon Jul 01, 2019 10:40 am

Hi there! For many months my n2 Plus had printed very well and I also used different nozzles to get really fine quality. But, a few weeks ago the prints are pretty bad.
First off all my Bondtech extruder clocked a few times, than I´ve changed the PTFE tube. No better results. I also changed the nozzles and today I switched the complete heat block....also with no better results.
I have also reset the printer to factory result.

So I´m really out of ideas what it could be. Maybe some of you could help me. I have attached an image from a typical print.

Posts: 26
Joined: Wed Dec 13, 2017 6:41 am
Location: Qld, Australia

Re: Bad prints / heavy issues

Postby Daws » Thu Jul 11, 2019 12:04 am

This looks like not enough filament, did you change your extrusion width settings in the slicer?
CAD-NX Printer-Raise3D N2

User avatar
Posts: 180
Joined: Mon Jun 12, 2017 5:10 am

Re: Bad prints / heavy issues

Postby jetdillo » Thu Jul 11, 2019 6:23 pm

If you're having problems with your Bondtech, check to make sure the set-screw on the inside gear is tight and not causing the gear to wobble and make the filament bind. I ran into this last year and it took me a while to figure out. The symptoms jumped all over the place, just like the gear :D :roll: ... ech#p32520

User avatar
Posts: 469
Joined: Sat Nov 26, 2016 12:54 am
Location: Borås, Sweden

Re: Bad prints / heavy issues

Postby Noren » Fri Jul 12, 2019 5:03 pm

It looks like you have choosen 3 mm filament rather than 1,75 mm in the slicer. Do you use IdeaMaker? I did that mistake with cura and got something similar.

Return to “N Series”

Who is online

Users browsing this forum: No registered users and 1 guest