CAMERA VIDEO

Discussions about ideaMaker and other printing software.
Redron357
Posts: 12
Joined: Wed Mar 01, 2017 1:37 am
Location: Oshawa Canada

CAMERA VIDEO

Postby Redron357 » Sun Apr 14, 2019 7:32 pm

Hello all,
1 Camera is installed setting correct as per Raise3D support Kevin. on the dash board I see the short video and I export it and all I get is a Picture of the bed, no print video.
2 camera is clear at something close to the lens but where the printing is done seems like the lens is out of focus.


All this was done...
For timelapses, you will first have to enable the setting to export it to external storage. You will have to navigate to Settings -> More Settings -> Privacy and Security -> Enable Exporting Timelapse FIles to External Storage. Once that setting is enabled, you can then navigate to the Print tab and go to the Dashboard where you can see a history of your prints. You can export the timelapse to a connected USB drive through the icon shown in the attached image. The file will export out in .mp4 format. Keep in mind that these instructions are according to Raisetouch version 1.2.0 so you may need to update if you do not see that option

User avatar
Vicky@Raise3D
Posts: 5061
Joined: Fri Mar 25, 2016 3:54 am

Re: CAMERA VIDEO

Postby Vicky@Raise3D » Tue Apr 16, 2019 5:56 pm

Would you like to share us the video or image you export from touchscreen so that we can help check what's going on?
Is it possible to have the out of focus lens issue also shown in a video?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests