Dual Nozzle Temperature Control During Exchange

Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
rojas23
Posts: 5
Joined: Thu Jan 03, 2019 9:47 pm

Dual Nozzle Temperature Control During Exchange

Postby rojas23 » Mon Feb 04, 2019 11:38 pm

Hi,

If there is not already, may there be a feature for simultaneous inactive nozzle cool down while the other heats up? (in a location away from the part)

Currently, we can move in a location away from the part and heat up the nozzle that is about to print but we cannot cool down the nozzle that just finished its layer until the new layer starts and the just heated nozzle is already printing. Therefore, there is still oozing/stringing clinging to the part from the nozzle that starts cooling down only when this new layer has begun.

The overall temperature exchange process should be done before the next layer begins. One heats up and the other cools down. THEN a new layer can begin.

Thank you!

User avatar
Vicky@Raise3D
Posts: 5056
Joined: Fri Mar 25, 2016 3:54 am

Re: Dual Nozzle Temperature Control During Exchange

Postby Vicky@Raise3D » Tue Feb 05, 2019 8:29 pm

You can check out this section in ideaMaker to see whether it meets for your needs or not.
1.jpg

rojas23
Posts: 5
Joined: Thu Jan 03, 2019 9:47 pm

Re: Dual Nozzle Temperature Control During Exchange

Postby rojas23 » Sat Feb 09, 2019 1:55 am

Hi,

Thank you for the reply. As shown in the image below, by checking "Cool Down Inactive Extruder", cooling down only occurs during printing. I believe it would be beneficial if the extruder was cooled down "before" printing occured.

ideamaker_dual extrusion snip.jpg

User avatar
Vicky@Raise3D
Posts: 5056
Joined: Fri Mar 25, 2016 3:54 am

Re: Dual Nozzle Temperature Control During Exchange

Postby Vicky@Raise3D » Tue Feb 12, 2019 2:15 am

We should have already fixed this issue and will have the unused nozzle start cooling down once the start code completed from the next version.


Return to “Feature requests, ideas, wishes”

Who is online

Users browsing this forum: No registered users and 0 guests