M2000 does not work.
When i put it in code manually, or via ideaMaker, for example at 0.6mm (0.3 layer height) it pauses, then i hit hesume and it pauses again. And again, and again...
None of G-codes for pause that i found doen not work. So, how i can see, M2000 is the only option. And it does not work.
What should i do? I need this pause.
Please post your suggestions for software changes here
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests