Thoughts about Raise3D, 3D printing and making in general.
4 posts • Page 1 of 1
I have been having an issue with some of my prints. I am getting a layer that splits but seems to happen on taller prints vs shorter prints. I am attaching pictures of the latest item it printed. I am using matterhackers build series PLA which seems to print better at higher temps currently printing at 224c. It seems to only happen once during the print then continues normally. I am at a loss as to why it does it. I am new to printing only 2 months in so trying to figure out what the problem is. Any suggestions are greatly appreciated.
Too me it looks as if you are printing with a nozzle temp a little too high. a nozzle strike or extruder skip can cause this. here is a good site to check out https://www.simplify3d.com/support/print-quality-troubleshooting/
If it's happening at that height specifically (if you have other prints to compare it to to verify), it could be something off with the z-axis. Something may be interfering or causing it to skip ever-so-slightly, creating that gap in the layer.
Who is online
Users browsing this forum: No registered users and 1 guest