Help with end gcode when printing wood filament

Discussions about ideaMaker and other printing software.
Posts: 220
Joined: Wed Mar 25, 2020 7:42 am

Help with end gcode when printing wood filament

Postby FOGD.NO » Sat Apr 10, 2021 1:38 pm

I am printing with wood filament at 165-185c and it is prone to clog/burn if left in the nozzle, so I want it to purge filament and then retract enough to exit the hot zone after it is done printing.

Does this look good? Not sure how far I need to retract, so if anyone else got any hint about how much I should retract then please let me know. I want enough for it to be in the top part of the heat break, but not so much that it unload.

M221 T0 S100
M104 S0
M140 S0
G1 E-1 F300
G1 Z+0.5 E-5 Y-20 F9000.00
G28 X0 (Park the head left)
G1 E20 F200.00 (Purge filament)
G1 E-20 F9000.00 (retract enough to exit hot zone)
G28 Y0 (home Y)
-{Prototype Guru}-
Raise3d E2 w/SliceEngineer
Prusa MK3s Custom designed (Uploaded at Grabcad)
Prusa Mini
Creality CR-30 Beltprinter

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests