What I did:
- took the 20mm_calibration_box example and set flow rate under "filament settings" to 60% and exported the gcode.
- Did the same with 100% flowrate
- Compare the 2 gcode files
When looking at the gcode files in both cases the M221 command gives 100.
When enabling the option "Change Gcode E length by multiplying filament flowrate and redoing the test both gcode files show the same E lengths.
Do I have to enable something else or change flowrate in another place?
Os = windows 10 64 bit
Ideamaker version: 184.108.40.20635 Beta