Spiral mode - speed not being lowered automatically

Discussions about ideaMaker and other printing software.
roufster
Posts: 3
Joined: Sun May 26, 2019 3:25 pm

Spiral mode - speed not being lowered automatically

Postby roufster » Sat Aug 31, 2019 12:09 pm

Hi,

I am trying to print a file in vase mode and in the cooling section, i have 15 sec minimal layer speed and lowering speed enabled. However, if you look at the attached preview, it is all the same speed and the thin throat is not printing properly obviously. Tried increasing the minimal speed time. Same thing.

Any ideas as to why? Is the lowering speed not taken into consideration in vase mode?

User avatar
Vicky@Raise3D
Posts: 5618
Joined: Fri Mar 25, 2016 3:54 am

Re: Spiral mode - speed not being lowered automatically

Postby Vicky@Raise3D » Wed Sep 04, 2019 12:32 am

Would you like to share .idea, .gcode and .data files with us to have a look?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest