Keeping the bed hot

Discussions about ideaMaker and other printing software.
Posts: 7
Joined: Wed Aug 28, 2019 7:08 am

Keeping the bed hot

Postby santro » Wed Aug 28, 2019 8:12 am

Hi all this might end up being a duplicate post not sure where my first post went..
Currently ideamaker is turning the bed temp off after the first few layers, how to I set ideamaker to leave the bed temp on until the print is finished

User avatar
Posts: 6507
Joined: Fri Mar 25, 2016 3:54 am

Re: Keeping the bed hot

Postby Vicky@Raise3D » Wed Aug 28, 2019 9:38 pm

If you didn't enable Temperature Control List for Heated Bed, the temperature of bed wouldn't be changed by ideaMaker during the whole printing.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest