Hi all this might end up being a duplicate post not sure where my first post went..
Currently ideamaker is turning the bed temp off after the first few layers, how to I set ideamaker to leave the bed temp on until the print is finished
Keeping the bed hot
- Vicky@Raise3D
- Posts: 8746
- Joined: Fri Mar 25, 2016 3:54 am
Re: Keeping the bed hot
If you didn't enable Temperature Control List for Heated Bed, the temperature of bed wouldn't be changed by ideaMaker during the whole printing.
Who is online
Users browsing this forum: No registered users and 1 guest