What is the part, and why is it smoking and loose?

walleywalker
Posts: 31
Joined: Sat Sep 08, 2018 10:02 pm

What is the part, and why is it smoking and loose?

Postby walleywalker » Sat Aug 17, 2019 9:50 pm

I have a Raise3D pro 2 that I've owned for about a year now.

I just noticed as I was pre-heating the bed that this part was smoking badly - It smelled like burnt hair. I rushed over to the machine and turned it off and haven't been able to re-create it.

That said the part is loose and looks singed like it had been on fire.

Anyone care to help me out on what this piece is? Can it be replaced?

Video of the thing being wiggled around: https://youtu.be/uYqGQ0lkU04

Image

walleywalker
Posts: 31
Joined: Sat Sep 08, 2018 10:02 pm

Re: What is the part, and why is it smoking and loose?

Postby walleywalker » Sat Aug 17, 2019 9:56 pm

It looks like it's just a terminal block.

Should I be worried about this failing again if I replace it?

EldRick
Posts: 373
Joined: Thu Jun 22, 2017 5:55 am

Re: What is the part, and why is it smoking and loose?

Postby EldRick » Sat Aug 17, 2019 10:04 pm

Start by tightening the screw in each of the small holes. If any of them are at all loose, that's probably the source of the problem - a poor connection that heated up.
If tightening the screws fixes the issue temporarily, replace the whole terminal block anyway. Most hardware stores will have them.

User avatar
Vicky@Raise3D
Posts: 5618
Joined: Fri Mar 25, 2016 3:54 am

Re: What is the part, and why is it smoking and loose?

Postby Vicky@Raise3D » Sun Aug 18, 2019 11:56 pm

The terminal block looks already damage which may cause further damage to the printer if keep on using it.
Please contact our support.We can offer diagnose and free parts for you to replace if your printer is still under warranty,


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest