I'm not sure if this has been already addressed before:
For me it is very annoying (!!!) to be forced going to my printer and pressing 2 buttons after each print. You should really make this 'feature' configurable if somebody needs it. I'm aware that it needs some attention to not start a print with parts left in the printer, but hey - it's the users responsibility!
My printer is equipped with a camera, so I can see what happens from my PC. Also, the printer is powered by a WiFi controlled power plug. So normally, I turn off my printer remotely after a print. If I print something again and turn it on remotely, I can't control anything on the printer before I didn't go to the printer and press the 2 buttons.
I really hope, you could improve this in one of the next RaiseTouch updates - thanks!
Print complete message on N2 touch screen
- Vicky@Raise3D
- Posts: 5758
- Joined: Fri Mar 25, 2016 3:54 am
Re: Print complete message on N2 touch screen
Sorry for the trouble. We will try to open more options in future versions to meet different needs of different users.
Re: Print complete message on N2 touch screen
You aren't the first person to voice this complaint. (There may be others.)
https://forum.raise3d.com/viewtopic.php?f=3&t=16234
https://forum.raise3d.com/viewtopic.php?f=3&t=16033
https://forum.raise3d.com/viewtopic.php?f=3&t=16234
https://forum.raise3d.com/viewtopic.php?f=3&t=16033
Re: Print complete message on N2 touch screen
It's always good to know, I'm not the only strange person on this planet... 

Re: Print complete message on N2 touch screen
I concur - having to walk into the printer room for the button-presses is a PIA.
Who is online
Users browsing this forum: No registered users and 0 guests