we have just started printing with Raise3D Premium PETG and i just printed a test cube with the standard profile which comes with ideamaker.
we seem to be getting these imperfections around the middle of the print as shown in the attachments.
This is on a Pro2 plus with a 255 temp and 60 bed with a .4 nozzle
We also seem to be getting warping even with a raft. Should the enclosure lid be kept on for this as well as the door closed? we have had the lid off and door open for PLA due to some warping
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests