Raise3D at CES2019 - Is there any difference between N2 and Pro2?

[flexrc]

In case you are like me and have N2 printer and were wondering about differences between them, I've came to Raise3D booth and made a short video of things I've observed:
https://www.youtube.com/watch?v=9oPWWKM4liA

[Vicky@Raise3D]

Camera, run-out sensor, silicone cover are also available for N series printers, but just needs to be installed on different
Air filter, magnets for doors and build plate are newly built features on Pro2 series only.
Heated bed, motion board and firmware are all from a new system.
More unique features on Pro2 series, you can check out the following video: https://www.youtube.com/watch?v=pgj37MU ... e=youtu.be.