I printed this part 4 times it comes out very nice till the 3 or 4 layer then it gets bad. Seems to be scraping the layer with the nozzle but not on the first few layers.. I attached my settings also if anyone has advice how to fix this.Thanks
Thoughts about Raise3D, 3D printing and making in general.
3 posts • Page 1 of 1
What size nozzle are you using? Why is your extrusion width set so large? I mean, your extrusion width is 4x your layer height. This is very likely the problem. Maybe try dialing that down to about 0.4mm (that's assuming you are using a 0.4mm nozzle).
Who is online
Users browsing this forum: No registered users and 1 guest