Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
3 posts • Page 1 of 1
I am printing a planetary gear and the machine stops when im printing the ring (green) and just prints a layer of the model. At first i thought that it was the size of the model that it was so near to the extremes so i cuted the ring in 3 parts and everything went well this time, but then trying to print the planets and solar gears it stopped again and i had just a fine layer of materials until a 3rd attepmt I was finally able to print them Does anybody knows why this happens? is it my solidworks file or its a hardware issue?[img][/img]
Who is online
Users browsing this forum: No registered users and 1 guest