Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
6 posts • Page 1 of 1
Ran a simple cube as a test this morning, and all of a sudden, I got terrible layers. Bed adhesion was good. No grinding or anything of the nozzle on infill. Bed was at 60 for initial layer, extruder at 195. Any ideas? Obviously I must have adjusted some setting without realizing it, I just don't know which.
Alex M. wrote:Do you have a single extruder or layer controlled fan? There is a weird "feature" in ideaMaker which I thought was a bug. viewtopic.php?f=3&t=6299&start=40#p30429
Turns out, it was a filament jam issue. Not an over extrusion, but an under extrusion. Thanks though!
Who is online
Users browsing this forum: No registered users and 2 guests