Printing start

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 8
Joined: Fri Mar 24, 2017 7:12 pm

Printing start

Postby vortex3d » Wed May 16, 2018 6:52 pm

Hey guys, really need your help, i want to start my print at 24.2mm from the build plate. Want to restart a print after end of filament .
:oops: :oops: Thanks for your help

User avatar
Posts: 110
Joined: Wed Apr 20, 2016 2:40 pm
Location: New York

Re: Printing start

Postby sgeolog » Mon Jun 11, 2018 7:19 pm

I have sometimes the same problem. I open the model with Netfabb software and make a cut where is stopped printing. Then print upper part and "glue" parts together with 3D pen or with retouching tool for 3D prints.
Donimo Site A.jpg

You can see I did it twice. Maybe not the best solution but works for me. You can try to print second part changing Z but you have to know exact height of first part and without support of course

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests