I experience a weird problem on one of my two Raise E2 printers, on standard PLA.
I cannot get my test part to print correctly on one Raise, whereas it prints super-fine on the other. Same settings, same templates, same material, same extruders etc. etc.
As you can see on this image, the first 40 (or so) layers are printed fine, and then, the next layers are a mess.
Just note that this always happen roughly at the 40th layer level...
I double-checked the extruder and it is not clogged. I pruged it of previous ASA jobs, at 240°C so that it is clean of any left ASA material.
If anybody has a clue of whats hapenning here...
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests