I have an issue where i have moved to raise3d pro2 plus printer and have a g code file from my old printer creality s5 and no longer the cad file or stl as laptop imploded and lost everything , therefore I would like to get this to fit on my new printer.
I've worked out adjusting G92 with an offset of X70 Y30 moves it to the correct place when printing, opposite looking when loaded onto idea maker. This worked with bringing everything into the right position BUT now the right hand side doesn't print like its been sliced there, assuming this is due to values in gcode being over the 305mm? Tried making printer bigger in setting but no luck with that
Red line where it stops printing
Is there a way of resolving this please really don't want to spend many hours again drawing it......
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest