Preheating During Homing???

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Online
D_E
Posts: 8
Joined: Thu Jul 21, 2022 12:41 pm

Preheating During Homing???

Postby D_E » Wed Jul 27, 2022 10:43 am

I've got a Pro3 at work. The homing process is clunky and takes a while. You'd think that the firmware would take the opportunity to preheat the bed and nozzles, but it doesn't. I looked through the settings, but I haven't seen anything. Does anyone know if this is possible?

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest