good morning congratulations, for the excellent forum
Good prints for the whole community.
I'm trying to replace the creality slice with the ideamaker, but after a week of trying it has been disappointing, I still couldn't find the correct configuration, for example shells, 0.8 in the crealty 0.8 ideiamaker, they are very thin, I have to change it to 1.2 to look like,
but this among other problems . Can anyone help?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest