Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Has anyone been successful in printing sunlu pla or petg. I can print it with my anycubic at home, but im having really bad luck printing on the pro 2. Both keep jamming near the nozzle or something. almost like its expanding the end of the filament and then getting stuck. it will measure almost 2 mm after it jams but measures 1.75 mm before. I understand sunlu isn't on open filament program but didn't think it would matter too much
Who is online
Users browsing this forum: No registered users and 1 guest