using sunlu pla and petg

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
RTPN92
Posts: 6
Joined: Thu Sep 24, 2020 6:18 pm

using sunlu pla and petg

Postby RTPN92 » Tue Feb 16, 2021 9:49 pm

Has anyone been successful in printing sunlu pla or petg. I can print it with my anycubic at home, but im having really bad luck printing on the pro 2. Both keep jamming near the nozzle or something. almost like its expanding the end of the filament and then getting stuck. it will measure almost 2 mm after it jams but measures 1.75 mm before. I understand sunlu isn't on open filament program but didn't think it would matter too much

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests