Use both extruders for large prints (and LED question)

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
rees3d
Posts: 1
Joined: Fri Nov 08, 2019 10:36 am

Use both extruders for large prints (and LED question)

Postby rees3d » Fri Nov 08, 2019 10:40 am

Hi,

I am trying to setup my Pro2 Plus to use both spools with the same filament for large prints.
The idea is when the filament runs out on one spool it will start using the filament on the other spool.

Also, it is possible to turn off or dim the lights of the LEDs that are installed inside the printer?

Thanks!

Patronus
Posts: 35
Joined: Mon Jul 01, 2019 11:09 am

Re: Use both extruders for large prints (and LED question)

Postby Patronus » Thu Nov 14, 2019 3:18 pm

There's unfortunately no automated way to switch from one extruder to the next when filament runs out. It would be a useful feature though especially since these machines are often used for large prints. I think others have asked for the same feature before.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests