why half of the model is not good?

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 8
Joined: Wed Aug 28, 2019 9:08 pm

why half of the model is not good?

Postby xuguo » Tue Sep 03, 2019 4:54 pm

Hello all,
Does anyone knows why one side of the mode is good, but another side is so bad?
And it's also not good if you see the top view of the model. Why?
I printed the model in a vertical way, the length is 15cm. I found the bottom of the model is not so flat, so maybe I should add a bigger raft?

Thanks guys!
webwxgetmsgimg (3).jpg
webwxgetmsgimg (2).jpg
webwxgetmsgimg (1).jpg

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests