How do I go about doing the following:
Outer shell (left nozzle 1mm) ABS 1mm extrusion width, 250C, 50mm/s, 2mm retraction and a few other individual settings
Infill (right nozzle 0.6mm) CF/Nylon 0.6mm extrusion width, 270C, 60mm/s, 4mm retraction and a few other individual settings
With Cura it's easy, I adjust the individual settings for each nozzle and save the whole lot as one profile. But with Ideamaker I don't see an obvious way achieving this. Any advice?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests