I tried "The Calibration Cat" (https://www.thingiverse.com/thing:1545913) recently on Pro2 Plus, and here is the result.
You should be able to see that the tail was not printed very well, while everything else seems OK.
Would this be considered an overhang issue? And if so, what can I do about it?
I used 0.2mm layer height, and standard PLA recommended by Raise3d. The slicing software was IdeaMaker.
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests