we are using a Raise3D Pro2 for 4 months now.
Most of the time we print with Raise3D Premium Filament. We had very good results with it.
Now, we are using Raise3D Standard Filament and we have Problems with unbonding.
Settings in IdeaMaker:
Raft with Skirt
Layer high: 0.1mm
The result is like this below.
the sides are not straight, but they should
does anyone have any hints for parameters?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests