Page 1 of 1

Pro2 - Importing Setting to Right Extruder

Posted: Mon May 13, 2019 4:38 pm
by bajud
Good day! I wonder if there's a way to directly import settings of a specific filament to the Right Extruder. Currently I downloaded the Polyflex settings from Raise3D site but importing places the whole settings to Left Extruder.

I'm thinking of printing the lower section of my part in PLA (Left Extruder) and some upper section in flex (Right).

Thanks,
Bajud

Re: Pro2 - Importing Setting to Right Extruder

Posted: Tue May 14, 2019 2:20 am
by Vicky@Raise3D
You can user Compare Templates under Select Template -> Compare or Slice -> Compare Templates to compare the different settings between your PLA and Flexible templates. Then add those settings into Per-Layer Settings. The Start Z of Per-Layer settings should start from your upper section printed with flexible material.
You can find more information from the following links:
https://support.raise3d.com/ideamaker/4 ... ent_id=804
https://support.raise3d.com/ideamaker/5 ... ent_id=458
https://support.raise3d.com/ideamaker/4 ... ent_id=841

Re: Pro2 - Importing Setting to Right Extruder

Posted: Tue May 14, 2019 9:28 pm
by crimsonyoshi
In your slicing template, you can specify which nozzle to use for your model, infill and support. If it's importing the settings to your model, copy those to your support tab (if it's support material you're using there) and set the support to the right nozzle. Restore your settings for your left nozzle.

I don't know if you can directly import non Raise3D templates properly or not!

Re: Pro2 - Importing Setting to Right Extruder

Posted: Fri May 07, 2021 9:27 am
by Quteiba_
After compare two Templates and show the compare settings, are there any possibility to export the compared Settings inside a new Excel Table? that will be very helpful funktion.

Re: Pro2 - Importing Setting to Right Extruder

Posted: Sat May 08, 2021 1:57 am
by Vicky@Raise3D
It has been added into developing list already. We will release it in future versions.