Pro2 - Importing Setting to Right Extruder

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 8
Joined: Thu Jun 28, 2018 11:01 pm

Pro2 - Importing Setting to Right Extruder

Postby bajud » Mon May 13, 2019 4:38 pm

Good day! I wonder if there's a way to directly import settings of a specific filament to the Right Extruder. Currently I downloaded the Polyflex settings from Raise3D site but importing places the whole settings to Left Extruder.

I'm thinking of printing the lower section of my part in PLA (Left Extruder) and some upper section in flex (Right).


User avatar
Posts: 6925
Joined: Fri Mar 25, 2016 3:54 am

Re: Pro2 - Importing Setting to Right Extruder

Postby Vicky@Raise3D » Tue May 14, 2019 2:20 am

You can user Compare Templates under Select Template -> Compare or Slice -> Compare Templates to compare the different settings between your PLA and Flexible templates. Then add those settings into Per-Layer Settings. The Start Z of Per-Layer settings should start from your upper section printed with flexible material.
You can find more information from the following links: ... ent_id=804 ... ent_id=458 ... ent_id=841

Posts: 119
Joined: Mon Sep 24, 2018 6:17 pm
Location: Manitoba, Canada

Re: Pro2 - Importing Setting to Right Extruder

Postby crimsonyoshi » Tue May 14, 2019 9:28 pm

In your slicing template, you can specify which nozzle to use for your model, infill and support. If it's importing the settings to your model, copy those to your support tab (if it's support material you're using there) and set the support to the right nozzle. Restore your settings for your left nozzle.

I don't know if you can directly import non Raise3D templates properly or not!

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests