PEHD, Polyethylene high density

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
martialgeudin
Posts: 16
Joined: Wed Jan 02, 2019 10:00 am

PEHD, Polyethylene high density

Postby martialgeudin » Fri Mar 01, 2019 9:32 pm

Does someone already used PEHD on a Raise3D Pro2? What are the recommandations for printing with this material? What settings to use, what is the building bed made of? Are there some examples made with this material? What are the issues and what can be done on it?

EldRick
Posts: 380
Joined: Thu Jun 22, 2017 5:55 am

Re: PEHD, Polyethylene high density

Postby EldRick » Sat Mar 02, 2019 4:44 pm

I haven't tried printing it, but I'd bet that it won't stick to any bed material or treatment.
Perhaps the perforated circuit-board bed used on some printers might create enough mechanical attachment to hold a piece in place?


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests