Flexifill FormFutura settings

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Shelton
Posts: 388
Joined: Thu Jul 12, 2018 8:34 pm

Flexifill FormFutura settings

Postby Shelton » Tue Jan 29, 2019 7:28 pm

Ok, first you should te remove tubes from the extruder or use oil. Friction totally stops filament is not possible to pull it out from spool with tubes... second warping... I'm using blue tape or Kapton but still, after few layers, it can pell of at corner... Any ideas?

Return to “Printing Settings”

Who is online

Users browsing this forum: Baidu [Spider] and 2 guests