Zits on plain wall

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Shelton
Posts: 375
Joined: Thu Jul 12, 2018 8:34 pm

Zits on plain wall

Postby Shelton » Thu Dec 20, 2018 1:33 pm

How to avoid those zits?
IMG_3373.jpg

User avatar
Vicky@Raise3D
Posts: 4947
Joined: Fri Mar 25, 2016 3:54 am

Re: Zits on plain wall

Postby Vicky@Raise3D » Thu Dec 20, 2018 11:25 pm

Please make sure that you are using the latest version of RaiseTouch, Motion Board firmware and ideaMaker.
And start from default settings in ideaMaker.

The Zits you marked in your picture are the Layer Start Points. Due to filament oozing on nozzles, there is always some filament left on nozzle tips before nozzle reaches to the Layer Start Points. You can tune some retraction and cooling settings in ideaMaker to see whether you can make the zits less obvious. But it will be hard to totally removed.
Or you are set Layer Stater Point's position at a fixed position, so that you can get all zits gathering together which can be easier to carry out post-process. Or set it as random, so that each layer's start point will be separated which may look not as obvious as before.

Shelton
Posts: 375
Joined: Thu Jul 12, 2018 8:34 pm

Re: Zits on plain wall

Postby Shelton » Fri Dec 21, 2018 6:36 am

I’m using last firmware but not Idea Maker. I will to change start points. Thank you.


Return to “Printing Settings”

Who is online

Users browsing this forum: Bing [Bot] and 2 guests