Benchy Boat Squished

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 1
Joined: Tue Dec 18, 2018 8:30 pm

Benchy Boat Squished

Postby jcmglade » Tue Dec 18, 2018 8:44 pm


Environment: Raise3d N2 Plus with Ideamaker 3.3 and Raise3d White PLA 1.75 filament.

I am trying to print out a benchy boat ( with the standard quality (middle one) without much success. Every benchy seems to be squished in the lower third of the boat.

Attached is a picture of the issue and the gcode (zipped)

Any suggestions would be appreciated.
(1.05 MiB) Downloaded 11 times
2018-12-18 15.26.22.jpg
2018-12-18 15.25.54.jpg

Posts: 3
Joined: Fri Dec 29, 2017 1:18 am

Re: Benchy Boat Squished

Postby stugpanzer » Mon Jan 14, 2019 9:26 pm

What Material and what Temp are you printing at also what is the bed temp? I have seen this with PLA being printed too hot and/or the bed being too hot.

Posts: 89
Joined: Mon Sep 24, 2018 6:17 pm
Location: Manitoba, Canada

Re: Benchy Boat Squished

Postby crimsonyoshi » Tue Jan 15, 2019 2:57 am

Double check your bed height is set correctly from the nozzle. That looks like the nozzle is lightly impacting the previous layer’s print and re-melting it somewhat.

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests